Event Reporting; Tcp/Ip And Udp/Ip Auto Answer - Sierra Wireless AirLink ES440 User Manual

Rev 1 Nov.14
Table E-2: ALEOS Configurable Inbound Ports
Default
Port
161 SNMP Port
2332 SSH/Telnet Remote Login Server Port
9191 ACEmanager Port
9300 SSL tunnel Port
9443 ACEmanager SSL Port
12345 Device Port used for incoming TCP/
UDP traffic

Event Reporting

I set up ACEmanager to send an email/SMS report, but when I clicked
the Test report button no report was sent.
After you set up the event reporting fields and click Apply, wait about a minute
before you click the Test report button. The AirLink device needs this time to apply
the new configuration.
I configured event reporting, but I did not receive a report when I
should have.
• If the Action Type for the Event Reporting is Email or SNMP TRAP, be sure
that these services are also configured on the Services tab.
· To configure email, go to Services > Email (SMTP).
· To configure SNMP TRAP, go the Services > Management (SNMP).
•

TCP/IP and UDP/IP Auto Answer

I configured TCP/UDP auto answer, but the packet contents are not
being streamed over the serial port to the connected device.
1. Try polling the device connected to the AirLink device's serial port.
If you do not receive a response, confirm that the fields described in
ing IP to Serial with Auto Answer and Serial to IP
rectly.
2. In ACEmanager, go to Status > Serial and check the Serial bytes sent field to
confirm that packets are reaching the AirLink device from the mobile network
and the packet contents are being sent out the AirLink device's serial port.
Feature ACEmanager location
Services > Management (SNMP)
Services > Telnet/SSH
Services > ACEmanager
VPN > SSL Tunnel
Services > ACEmanager
Serial > Port Configuration
on page 220 are set cor-
Configur-
351