Led Operation - Sierra Wireless AirLink GX450 Hardware User's Manual

AirLink GX450 Hardware User Guide
For information on configuring the GX450 gateway, see
Gateways

LED Operation

Power-up and Reboot
On power-up or reboot, all LEDs turn red, then amber, then green. They then go through a
blinking sequence that ends with the Power LED green and all the other LEDs off. Once
the other LEDs resume their normal operating behavior, the reboot is complete.
To reboot the gateway:
•
•
LED Behavior
Table 2-3: LED Behavior
LED Color / Pattern
Power Off
Solid Green
Flashing Amber / Green
Solid Amber
Solid Red
Signal Solid Green
Solid Amber
Solid Red
Flashing Red
Rev. 11 July 2019
on page 44.
In ACEmanager, click the Reboot button at the top right of the screen.
Press and release the Reset button on the gateway (see
not hold the button down for more than a few seconds. (If you hold it for 7–10
seconds, the gateway resets to factory default settings.)
No power or input voltage
Gateway is connected to nominal power and is operating normally.
Gateway has a GPS fix
Gateway is entering low power mode or system low level boot.
Gateway is not operational (failure or in low power mode).
Good signal (RSSI
Marginal signal (-100 dBm
Poor signal (-110 dBm
No signal (RSSI
Configuring AirLink GX450
Description
≥ 36 VDC or
≥ -85 dBm)
< RSSI
≤ RSSI ≤ -100 dBm)
< -110 dBm)
30
Front Panel on page 8). Do
≤ 9 VDC
< -85 dBm)
4114008