Fitting The Shafts - Minelab F3Ci Service Manual

_______________________________________________________________________________________________________________________
Figure 75: Removing Coil from Shafts
b. The shafts have now been removed from the detector and can be replaced if required.
3.5.3 Fittin t e S afts
a. The detector body needs to be opened in order to fit the shafts to the detector, refer to
Section 3.1 – Opening the Detector
b. The coil must be fitted to the shaft then the shaft fitted to the detector this process is
described in Section
Assemble the detector as described in Section
c.
d. Once the detector is fully assembled check the operation of all moving parts and test the
detector as described in Section
Figure 76: Detector Shafts Assembly
Body.
3.4.6 - Fitting the Coil.
2 - Mechanical & Functional
3.2 - Closing the Detector
Testing.
45
F3Ci Service Manual
Body.