Minelab F3Ci Service Manual page 24

_______________________________________________________________________________________________________________________
Figure 31: Removing the Coil Connector Nut (18mm)
Remove the PCB screw from the main PCB, using a 2.5mm hex key driver.
•
Disconnect the battery connector from the main PCB.
•
Figure 32: PCB Screw, Battery Connector and Coil Socket
Slide the coil socket out of the detector body.
•
Disconnect the Earset cable assembly (internal) from the main PCB. Figure 33.
•
Disconnect the handle wiring loom from the main PCB.
•
Disconnect the vibration motor connector from the main PCB.
•
PCB Screw
24
F3Ci Service Manual
Battery Connector
Coil Socket