Minelab F3Ci Service Manual page 21

_______________________________________________________________________________________________________________________
Do not move the detector with the hinge cover removed as this may result in the spring
Confirm coil connector is tight and check the coil cable and the wiring loom are
•
located into the cable router.
Check the latch and spring are connected as shown in Figure 25. If the latch and
•
spring have become disconnected they must be reconnected. It is possible to
reattach the eyelet of the spring to the pin of the latch hinge through the opening
under the hinge cover. Alternately the detector body can be opened to reattach the
spring to the latch.
Cables held in
Cable Router
Fit the hinge cover and make sure the protrusion on the underside of the hinge cover
•
engages into the slot on the detector body near the hinge. Fit the two screws
(45mm) into the hinge cover and tighten.
latch hinge and the latch hinge becoming disengaged.
Figure 25: Underneath Hinge Cover
•
•
•
•
•
•
•
Figure 26: Fitting Hinge Cover
Note
Spring Latch
Spring Eyelet
located on pin of
Latch Hinge
21
F3Ci Service Manual
Hinge