Minelab F3Ci Service Manual page 36

_______________________________________________________________________________________________________________________
3.4.2 Removing the Coil. Once completed:
Fit the O-ring to the coil as shown in Figure 60.
•
O-Ring
Figure 57: O-Ring
and Coil Cable
Identify the section of coil cable closest to the coil and wind or unwind the coil cable
•
to achieve five turns. The five turns of cable will be located within the pivot with the
pin coil pivot passing through the centre.
Feed the pivot coil yoke onto the coil cable and carefully move the pivot coil yoke
•
along the coil cable to the coil. Align and then push the pivot coil yoke into place on
the coil. Check the pivot coil yoke rotates through 90 deg with end stops.
Feed the pivot shaft onto the coil cable. Align the coil cable with the five turns of
•
cable inside the pivot then press the pivot shaft onto the pivot coil yoke. Ensure the
coil cable retains the five turns of cable within the pivot.
Push the pin coil pivot into the pivot coil yoke. The pin must travel up the centre of
•
the five turns of cable inside the pivot. If there is resistance to inserting the pin open
5 Coils inside
Pivot
Figure 58: Fitting Pivot Coil Yoke
Pivot Coil Yoke
Figure 59: Fitting Pivot
Lower Shaft
36
F3Ci Service Manual
Pivot Lower
Shaft