Minelab F3Ci Service Manual page 20

_______________________________________________________________________________________________________________________
Identify the four Torx screws (star) and check they all have O-rings fitted. Insert the
•
four Torx screws into the right side of the detector. The Torx screw positions have a
Torx symbol next to their screw holes. Insert the three long screws first.
Torx Screw symbol
marks location of
all Torx Screws
Check the detector assembly and test all moving parts.
•
Place the detector on its right side. Remove the hinge cover then insert and tighten
•
the two screws (35mm) into the shaft hinge.
Figure 22: Fitting Four Screws
O-ring
Figure 23: Fitting Torx Screws.
Figure 24: Fitting Screws into the Shaft Hinge
20
F3Ci Service Manual