_______________________________________________________________________________________________________________________
3.8.1 Battery Lid Replacement
a.
Open the detector body as described in Section
completed:
The battery lid can be replaced without opening the detector body if the tether is unscrewed from
Check the battery lid has an O-ring correctly in place. The O-ring must be clean and
•
can be lightly greased.
Check the battery lid closes onto the battery compartment. Fit and close the battery
•
lid.
b.
Close the detector body as described in Section
3.8.2 Battery Compartment Replacement
a.
Open the detector body as described in Section
completed:
Disconnect the battery connector. Figure 87.
•
Remove the two screws (12mm) from the battery compartment.
•
Slide the battery compartment rearward (away from the main PCB), threading the
•
battery connector out of the detector body.
Refit the battery compartment by first feeding the battery connector through the
•
hole in the detector body.
Slide the battery compartment into position.
•
Connect the battery connector.
•
Refit the two mounting screws (12mm).
•
Close and lock the battery lid.
•
b.
Reassemble the detector by closing the detector body as described in Section
Closing the Detector
Figure 87: Replacing Battery Compartment
Body.
3.1 - Opening the Detector
Note
the battery lid.
3.2 - Closing the Detector
3.1 - Opening the Detector
Battery Connector
51
F3Ci Service Manual
Body. Once
Body.
Body. Once
3.2 -