Replacing And Fitting The Search Coil - Minelab EXPLORER II User Manual

REPLACING AND FITTING THE SEARCH COIL

Coil Cable
Yoke Bolt
Search Coil
Figure 2.14 Replacing the search coil
Pull cable down
from inside
shaft/yoke
Figure 2.15 Removing cable
Replacing the search coil
Figure 2.14–2.16
CAUTION DO NOT attempt to remove the coil cable from the
search coil. Any attempt to disconnect will void your
detector warranty.
To replace the search coil:
Disconnect the shaft assembly from handle assembly by
STEP 1
reversing the procedure outlined in Connecting the shaft
assembly on page 16.
CAUTION DO NOT attempt to remove the shaft assembly
without disconnecting the coil cable from the control box.
Separate the two shaft assemblies by releasing the shaft
STEP 2
camlock and sliding the lower shaft out.
P0607-A
(Figure 2.14) Loosen the yoke nut and carefully remove the
STEP 3
bolt from the yoke bracket. This removes the yoke from the
search coil. Be careful not to lose the two plastic washers.
THE MINELAB EXPLORER II
Rubber Washer
Coil Yoke
Yoke Nut
Yoke Bracket
(Continued next page)
REPLACING AND FITTING THE SEARCH COIL
P0608-A
27