Minelab F3Ci Service Manual page 15

_______________________________________________________________________________________________________________________
Using fingers gently separate the left and right body halves. The battery end of the
•
detector will come away easily. The shaft end is held by two locating pins and will
require more force to separate.
Gently lift the right side off the left body half taking care not to pull or stretch the
•
speaker cable and connector. Figure 13.
Locate the speaker connector on the PCB and disconnect the speaker from the PCB.
•
Remove the right half of the detector body.
Speaker Connector
Remove the upper shaft from the detector body taking care not to snag and damage
•
the coil cable and plug.
Figure 13: Disconnecting Speaker Connector
Figure 14: Removing Shafts
15
F3Ci Service Manual