Fitting The Coil Pivot - Minelab F3Ci Service Manual

_______________________________________________________________________________________________________________________
Separate the pivot lower shaft from the pivot coil yoke. Gently feed the coil cable
•
through the pivot lower shaft removing the pivot shaft from the coil cable. Do not
stretch the coil cable.
Pivot Lower Shaft
Pull the pivot coil yoke off the coil and carefully thread the coil cable through the
•
pivot coil yoke. If required remove the O-ring from the coil.
Note: F3Ci Coil
will be black
3.4.5 Fittin t e Coil Pivot
a. To fit the coil pivot, firstly remove the coil from the detector as described in section
Figure 54: Removing Pin Coil Pivot
Pivot Coil Yoke
O-Ring
Figure 56: Removing Pivot Coil Yoke
35
Figure 55: Removing Pivot Lower Shaft
F3Ci Service Manual