Minelab F3Ci Service Manual page 44

_______________________________________________________________________________________________________________________
Remove the pin coil cable from the upper end of the upper shaft. Turn the pin coil
•
cable clock wise and then lift out.
Remove the two nylon screws from the cap shaft on the lower shaft as indicated in
•
Figure 74.
Insert a flat tip screwdriver into the slot underneath the cap shaft and lift and
•
remove the cap shaft.
Figure 74: Removing Screws from Lower Shaft
Slide the coil out and off the lower shaft, exposing the coil cable. Feed the coil cable
•
connector into the upper shaft and pull the coil cable out of the end of the lower
shaft. Figure 75
Figure 72: Shaft and Coil removed from Detector
Figure 73: Removing Pin Coil Cable
44
F3Ci Service Manual