Main Printed Circuit Board (Pcb) - Minelab F3Ci Service Manual

_______________________________________________________________________________________________________________________
Reattach the armrest with four screws (12mm).
•
Check all moving parts for correct operation.
•
Insert batteries, turn on the detector then conduct mechanical & functional testing
•
as described in Section 2

Main Printed Circuit Board (PCB)

3.3
The main PCB of the F3Ci is a line replaceable unit and this section of the manual
a.
describes the procedure for its replacement. Figure 28 shows the main parts associated with the
main PCB.
b. 3004-0133 Main PCB Kit, is a service kit containing the main PCB and the associated parts,
when a replacement main PCB is required this part number should be ordered.
Repairs to and disassembly of the main PCB are not detailed in this manual. Repairs to the
main PCB should only be conducted by authorised Minelab Engineers.
Battery Connector
Figure 28: Detector Body and Main PCB
Figure 27: Attaching the Armrest
Mechanical & Functional
Note
22
F3Ci Service Manual
Testing.
PCB Screw
Main PCB
Cable Ribbon
Speaker Connector