Cable Routing - Yamaha XT 600 AC Service Manual

CABLE ROUTING
~
Flasher light lead (right)
[8]
2 Clutch cable
3 Band
[BJ
4 Handlebar switch lead
(left)
®
Main switch
®
Handlebar switch lead
(right)
Front brake switch lead
~
Throttle cable
CABLE ROUTING
ISPECI
Pfl
Pass the brake hose through t he 2 . Connect the wires to the clutch
guide . switch, handlebar switch (left),
Clamp the handlebar switch lead meters and flasher light (left),
(left), clutch switch lead and speed - crossing the wires over the wires
ometer lead , above the handlebar used in step 1 .
switch lead (right), front brake 3 . After the wiring is completed, put
switch lead(right ) and main switch the couper underneath the meter
lead . and pilot box.
Align the white tape on the wirehar- 4 .Clamp the wires at the point
ness with the Headlightstay . where taping will stop near the
9 Brake hose
[OJ Pass the wireharness between t he wireharness .
10 Flasher light lead (left)
11 Main switch lead
1 Clutch switch lead
13 Pilot box lead
14
Brake hose guide
15 Wireharness
16 Clamp
1 Speedometer cable
18 Speedometer lead
19 Headlight lead
o
Position light lead (right)
@
Position light lead (left)
under bracket and front fender . (Locate the protection taped por-
[E
Procedure tion above the headlight rim .)
1 . Connect the wires to the flasher
light (right) , pilot box, fron t brake
[::tJ
Pass the clutch cable to the front
switch , handlebar switch (right) of the throttle cable.
and main switch .
2-24