Yamaha XT 600 AC Service Manual page 220

FRONT AND REAR BRAKE
ICHASI
~I
/
6-19
***********************
Installation steps:
• Connect a suitable hose
@
tightly to the cal-
iper bleed screw
@'
Then, place the other
end of this hose into an open container.
• Loosen the caliper bleed screw and push the
piston into the caliper by your finger.
• Tighten the caliper bleed screw .
Caliper bleed screw:
6 Nm (0.6 m'kg, 4.3 ft'lb)
• Install the pad shim (new)
®
to the piston
side brake pad .
• Install the pad springs (new) and brake pads
(new) .
NOTE: ________________________ __
Be sure to position the pad so that its round
side
@
is upward .
• Install the caliper body
@ .
NOTE: __________________________ __
Pl ace the rubber boot
(j)
securely in the groove
of guide pin when installing the caliper body .
** **** * ** *** * **********
5. Install:
• Retaining bolt
CD
Retaining bolt:
23 Nm (2.3 m'kg, 17 ft'lb)
6, Install:
• Caliper protector
®