Yamaha XT 600 AC Service Manual page 172

IENGI ~1
ENGINE ASSEMBLY AND ADJUSTMENT -~
------------------------------------------------------
4-66
A.C.MAGNETO
1. Install:
-Key
CD
- Plate washer
®
-Bearing
®
- Rotor
@
(with starter wheel gear)
-Washer@
-Nut
®
NOTE: ______________________ __
When installing the A.C. magnet rotor make
sure the woodruff key is properly seated in the
keyway of the crankshaft. Apply a light coating
of lithium soap base grease to the tapered
portion of the crankshaft end.
2. Tighten:
-Nut (rotor)@
Nut (rotor):
120 Nm (12.0 mokg, 85 ftold)
NOTE: ________
~----------------
Hold the rotor to tighten the nut (rotor) by the
rotor holder
(j) .
Rotor holder:
PIN. YS-01880
PIN. 90890-01701
CAU1fPN:
Do not allow the rotor holder to touch the
projections
®
on the rotor.