Ring Allocation For Door Intercom; Restoring The Default Settings On The Base Station - Gigaset 1054isdn User Instructions

10.06.1999
Operating the Comfort Mobile Unit

Ring Allocation for Door Intercom

If you want to install a door intercom, you can define which internal subscriber should be called
from the door intercom. This internal subscriber is then able to operate the door opener.
1. In the non-active mode press the
2. In the service menu select "System settings" and enter the system code (default = 0000)
3. From the next menu select "Equipment data"(page 134).
a/b line
a/b-connect. 9
new: Doorstation
OK
or
0 ...8
SAVE

Restoring the Default Settings on the Base Station

You can restore all of the default settings on the base station, for example, if you have lost track
of the current settings. To minimize the level of effort not all of the settings will be restored. With
this procedure the following:
a) Restored to
default settings
Settings
Configuration
1. In the non-active mode press the
2. In the service menu select "System settings" and enter the system code (default setting
0000) (see also page 133).
Initialisation
1054I-7A.FM
ß key and select "Service" from the main menu.
Select "a/b line" from the "Equipment
data" menu,
Scroll with NEXT...
until „a/b connection 9" is in the 1st line
and then select with OK.
Scroll with NEXT...
until "New: Doorstation" is in the 1st line
and then select with OK.
The following list is displayed; here, for
example internal subscriber 1 and 2 are
entered.
Press OK to verify
Enter single digit internal subscriber num-
ber, here 4; if needed, correct with
Use SAVE to confirm the call assignment.
b) Deleted:
Time units / costs
Emergency numbers
Restricted numbers
Multiple / installation numbers.
ß key and select "Service" from the main menu.
After entering the correct system code the
following menu is displayed:
(complete menu left)
Use NEXT to scroll the menu...
until "Initialisation" is in the 1st line and
then select with OK.
This display will be visible for 2 seconds.
Gigaset 1054 isdn, GBR: A30853-X200-B101-51-7619
System Settings
a/b-connect. 0
a/b-connect. 9
Internal 1
NEXT
active:Telephone
new
new
NEXT
Door call to
1 2 _
Door call to
1 2 4 _
.
c) Unchanged:
System code
Reg. mobile units
Ring allocation
Duration/Units
Call barring
Change Sys.Code
NEXT
Initialisation.
OK
:Doorstation
:Modem
OK
OK
SAVE
OK
set
135