Setting Ring Allocation On A System Connection - Gigaset 1054isdn User Instructions

10.06.1999
Operating the Comfort Mobile Unit

Setting Ring Allocation on a System Connection

On a system connection the call assignment is automatic based on the assignment of the inter-
nal subscriber numbers from the system number. You do not need to make any additional set-
ting.
In cases when you cannot be reached, for example, when your mobile unit is outside of the oper-
ational range of the base station, you can use call forwarding to determine where the call should
be transferred. You can define the internal call forwarding with either collection call or group call.
1. In the non-active mode press the
2. In the service menu select "System settings" and enter the system code (default setting
0000) (see also page 133).
Configuration
Point to P.
Call diversion
Call forwarding for collective call:
0... 9
or
Call forwarding for group ring:
0... 9
1... 9
1054I-7A.FM
ß key and select "Service" from the main menu.
After entering the correct system code the
following menu is displayed:
Scroll the menu with NEXT...
until "Configuration" is in the 1st line and
then select with OK.
Use NEXT to scroll to "Point to P ." and then
select with OK.
Scroll with NEXT to find "Call diversion" and
select with OK
Use OK to select "Collective div.".
Enter internal subscriber that
should be forwarded to,
here 1,2
Use OK to select "Group diversionl"
You can define two groups of inter-
nal subscribers that will be called
one after another.
Set the number of ring cycles,
before the call is forwarded.
Gigaset 1054 isdn, GBR: A30853-X200-B101-51-7619
System Settings
Duration/Units
Call barring
Change Sys.Code
NEXT
act:Point to MP
new:Point to P.
- - - - - - - -
NEXT
P/P-phone number
Call diversion
- - - - - - - -
NEXT
Collective div.
Group diversion
- - - - - - - -
NEXT
Call diversion?
1 2 _
Group diversion
- - - - - - - -
Collective div.
NEXT
Group diversion1?
_
Set number of
ring cycles
OK
OK
OK
OK
OK
OK
OK
3
SAVE
139