Table of Contents
Advertisement
10.06.1999
Operating the Comfort Mobile Unit
Connection / Operation Type of System: : Setting System Connection
The Gigaset 1054isdn can be operated both on a multiple device connection and a system con-
nection (see also page 9). Using the following procedure you can setup operation on a system
connection.
Using this setting your Gigaset 1054isdn can only be operated on a system connection that 1. In
the non-active mode press the
2. In the service menu select "System settings" and enter the system code (default setting
0000) (see also page 128).
Configuration
OK
or
NEXT
Point to P.
P/P-phonenumber
o
o
o
Note:
The length of the call number is limited to 8 digits.
After switching to the system connection, please restart the base station by unplugging the
power adapter and then plugging it in again.
92
1054I-7A.FM
ß
key and select "Service" from the main menu.
After entering the correct system code the
following menu is displayed:
Scroll in this menu with NEXT...
until "Configuration" is in the 1st line and
then select with OK
Press OK if you only wanted to verify
using NEXT search for "Point to P ." and
select with OK.
You have now set your system to system
connection
With OK select "P/P-phonenumber" .
Now enter the complete system call num-
ber:
National prefix
(e.g. 0049 for Germany),
After this enter the
local area code (e.g. 89 for Munich)
Last you enter the installation call
number that was assigned by the
phone company
Gigaset 1054 isdn, GBR: A30853-X200-B101-51-7619
Basic Settings
Duration/Units
Call barring
Change sys. code
NEXT
act:Point to MP.
new:Point to P..
- - - - - - - -
NEXT
P/P-phonenumber
Call diversion
- - - - - - - -
NEXT
0049_
National code?
123456_
P/P-phonenumber?
OK
OK
OK
SAVE
SAVE
Advertisement
Table of Contents
