Replacing The Media Feed Roller; Touching The Edge Of The Print Head With Your Bare Hand Could Cause Injury - SATO S84ex Operator's Manual

8 Appendix
8.7.4

Replacing the Media Feed Roller

You can easily remove and replace a damaged or worn media feed roller.
1
Make sure that the printer is in power off
mode, then disconnect the power cord
from the AC outlet.
2
Open the top cover.
CAUTION
Open the top cover fully to prevent accidental drop of
the cover.
3
Turn the head lock lever  clockwise to
unlock the print head.
CAUTION
• The print head and its surroundings are hot after
printing. Be careful not to touch it, to avoid being
burned.
• Touching the edge of the print head with your bare
hand could cause injury.
4
Pull the feed lock latch  to unlock the
feed roller and media sensor
assembly .
The feed roller and media sensor assembly will
flip open.
5
Loosen the screw  until the bearing
clamp  is released.
Do not remove the screw.
6
Remove the bearing  from the chassis
and the shaft of the media feed roller .
7
Pull out the media feed roller  from the
printer and replace it with a new media
feed roller.
324 S84-ex/S86-ex Operator Manual
3
7
6
5
4
1
2