SATO S84ex Operator's Manual page 152

4 Operation and Configuration
EXTERNAL SIGNAL
Set the output signal type of the print end signal (PREND).
The following options are available:
Type
TYPE1
TYPE2
TYPE3
TYPE4
Note
• Shows only if the external signal (EXT) function is enabled.
• Refer to the Timing Chart of the EXT Input Signal
EXTERNAL REPRINT
Set the reprint function by reprint signal from the external signal.
• ENABLE: Enable the reprint.
• DISABLE: Disable the reprint.
Note
The printer will not reprint if a command error occurs.
CONTINUOUS PRINT
Set the reprint function by the print start signal from an external signal.
• ENABLE: Enable the continuous print.
• DISABLE: Disable the continuous print.
150
S84-ex/S86-ex Operator Manual
Operation Details
The print end signal (PREND) is High before label
printing, and it becomes Low after print completion. The
signal level becomes High after 20 ms.
The print end signal (PREND) is Low before label
printing, and it becomes High after print completion. The
signal level becomes Low after 20 ms.
The print end signal (PREND) is High before label
printing, becomes Low from the start to the end of print,
and becomes High again after print completion.
The print end signal (PREND) is Low before label
printing, becomes High from the start to the end of print,
and becomes Low again after print completion.
for details.