Rfid Printing Tips - SATO S84ex Operator's Manual

Hide thumbs Also See for S84ex:

Table of Contents

8.11.4 RFID Printing Tips

Recommended non-printable zone

Avoid printing barcodes or characters directly on top

of an RFID chip. The uneven surface will negatively

affect the print quality.

The tag offset is adjusted from the base reference point.

The base reference point differs depending on the media

sensor you use. Refer to

Section 6.3.1 About the Base

Reference Point

for details.

When gap sensor is used, the tag offset is adjusted from

the tip of the label.

When I-mark sensor is used, the tag offset is adjusted

from the position after the I-mark.

Media feed direction

The position for the

best write success

rate on this inlay.

S84-ex/S86-ex Operator Manual

non-printable zone

Print object