Spool Valve - Jeep Wrangler 1997 Manual

Hide thumbs Also See for Wrangler 1997:

Table of Contents

DISASSEMBLY AND ASSEMBLY (Continued)

71,,~PRY BEARING

AT RAISED AREA

Fig. 9 Bearing Retainer

THRUST WASHER

Fig. 10 Adjustment Plug Components

Apply white petroleum grease to dust seal cav-

ity and install dust seal into adjuster plug with

remover/installer C-4177 and handle C-4171 .

(4) Install retainer snap ring.

(5) Install O-ring seal to adjuster plug .

(6) Install large bearing race, thrust bearing, small

bearing race and bearing spacer to adjuster plug.

(7) Install thrust washer bearing retainer to

adjuster plug (Fig. 12) .

CAUTION : When

adjuster plug,

should be taken not to cut the seals.

Install adjuster plug into housing with Spanner

Wrench C-4381 .

(9) Adjust bearing preload, refer to Thrust Bearing

Preload Adjustment.

Fig . 11 Needle Bearing Removal

Fig. 12 Install Retainer

(10) Install adjuster plug lock nut, and using a

punch (drift) in a notch, tighten securely (Fig. 13) .

Hold adjuster plug to maintain alignment of the

(11) Adjust pitman shaft, refer to Over-Center

Steering gear must be removed from the vehicle for

this procedure .

Troubleshooting