Jeep Wrangler 1997 Manual page 1013

TJ
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 37 Inner Weight Snap Ring
ASSEMBLY
CAUTION: Exercise care when installing the rings.
They are easily broken if overspread or twisted dur-
ing installation.
If it was necessary to remove the park gear,
inspect the seal rings and bore in rear support.
Install new seal rings on park gear hub only if orig-
inal rings are damaged, or worn. Install ring with
interlock ends first and ring with plain ends last.
Slip each ring on hub and seat them in grooves. Ver-
ify that rear ring ends are securely interlocked before
proceeding. If the bore in rear support is damaged,
replace the rear support.
(1) Lubricate governor components with Mopar
ATF Plus 3, Type 7176 transmission fluid before
assembly.
(2) Clean and inspect governor weights and bores
for scoring or wear. Replace the governor body and
weights if damaged. Refer to Cleaning and Inspection
section of this group for proper procedure.
(3) Insert spring into intermediate weight.
(4) Insert inner weight into intermediate weight
and install snap-ring (Fig. 38). Verify snap-ring is
fully seated in groove in intermediate weight (Fig.
37).
(5) Assemble governor weights into governor body
(Fig. 36).
(6) Install washer and snap ring to hold weights in
governor body.
(7) Install governor body in transmission
TRANSMISSION AND TRANSFER CASE
Fig. 38 Intermediate and Inner Governor Weights
VALVE BODY
DISASSEMBLY
Position the valve body on a clean work surface to
avoid contamination.
CAUTION: Do not clamp any part of the valve body
assembly (Fig. 39) in a vise. This practice will dis-
tort the valve body and transfer plate resulting in
valve bind. Slide valves and plugs out carefully. Do
not use force at any time. The valves and valve
body will be damaged if force is used. Also tag or
mark the valve body springs for reference as they
are removed. Do not allow them to become inter-
mixed.
(1) Remove screws
bracket to valve body and transfer plate. Hold
bracket firmly against spring force while removing
last screw.
21 - 107
attaching adjusting screw