Full Door Glass; Full Door Inner Belt Weatherstrip; Full Door Outer Belt Seal - Jeep Wrangler 1997 Manual

Hide thumbs Also See for Wrangler 1997:

Table of Contents

REMOVAL AND INSTALLATION (Continued)

FULL DOOR GLASS

(1) Remove the door trim panel and the waterdam.

(2) Pull the door glass run channel from the door

(3) Roll glass fully downward.

(4) Remove the door sail panel (Fig. 28) and (Fig.

(5) Roll glass 1/4 upward to access regulator arm

(6) Remove the screws that attach the regulator

arm guide to the glass.

(7) Lift the glass upward while tilting inward and

remove from the door.

Fig. 28 Door Sail Screws

Fig. 29 Door Sail Removal

INSTALLATION

(1) Position the glass in the door ensuring the

glass is aligned in the glass run channel.

(2) Install the screws that attach the regulator

arm guide to the glass.

(3) Install the door sail panel.

(4) Install the run channel in the door sail.

(5) Install the waterdam and the door trim panel.

The inner belt weatherstrip is attached to the door

trim panel and is not serviceable. If the inner belt

weatherstrip needs to be replaced, replace the door

(1) Remove the door sail panel.

(2) Disengage the clips attaching the outer belt

seal to the door (Fig. 30).

(3) Separate the seal from the door.

Fig. 30 Full Door Outer Belt Seal

INSTALLATION

(1) Position the seal on the door.

(2) Engage the clips attaching the outer belt seal

to the door.

(3) Install the door sail panel.