Jeep Wrangler 1997 Manual page 1034

21 - 128 TRANSMISSION AND TRANSFER CASE
DISASSEMBLY AND ASSEMBLY (Continued)
(4) Separate support from pump housing (Fig.
120).
(5) Remove inner and outer gears from reaction
shaft support (Fig. 121).
(6) If pump seal was not removed during transmis-
sion disassembly, remove seal with punch and ham-
mer.
(7) Remove front clutch thrust washer from sup-
port hub (Fig. 122).
Fig. 120 Separating Pump Housing From Reaction
Shaft Support
Fig. 121 Pump Gear Removal
Fig. 122 Support Hub Thrust Washer
OIL PUMP BUSHING REPLACEMENT
(1) Remove pump bushing with Tool Handle
C-4171 and Bushing Remover SP-3551 from Tool Set
C-3887-J (Fig. 123).
(2) Install new pump bushing with Tool Handle
C-4171 and Bushing Installer SP-5117 (Fig. 123).
Bushing should be flush with pump housing bore.
(3) Stake new pump bushing in two places with
blunt punch (Fig. 124). Remove burrs from stake
points with knife blade afterward.
Fig. 123 Removing Oil Pump Bushing
Fig. 124 Staking Oil Pump Bushing
REACTION SHAFT SUPPORT BUSHING REMOVAL
(1) Assemble Bushing Remover Tools SP-1191,
3633 and 5324 (Fig. 125). Do not clamp any part
of reaction shaft or support in vise.
(2) Hold Cup Tool SP-3633 firmly against reaction
shaft and thread remover SP-5324 into bushing as
TJ