Jeep Wrangler 1997 Manual page 1122

Hide thumbs Also See for Wrangler 1997:

Table of Contents

HEATING AND AIR CONDITIONING

REMOVAL AND INSTALLATION (Continued)

Remove the clutch plate with a puller (Special

Tool C-6461) (Fig. 13) .

(6) Remove the compressor shaft key and the

clutch shims.

(7) Remove the external front housing snap ring

with snap ring pliers (Fig. 14) .

Fig . 13 Clutch Plate Remove

Fig. 14 External Snap Ring Remove

(8) Install the lip of the rotor puller (Special Tool

C-6141-1) into the snap ring groove exposed in the

previous step, and install the shaft protector (Special

Tool C-6141-2) (Fig. 15) .

(9) Install the puller through-bolts (Special Tool

C-6461) through the puller flange and into the jaws

of the rotor puller and tighten (Fig. 16) . Turn the

puller center bolt clockwise until the rotor pulley is

(10) Remove the screw and retainer from the

clutch coil lead wire on the compressor front housing

(Fig . 17) .

(11) Remove the snap ring from the compressor

hub and remove the clutch field coil (Fig. 18). Slide

the clutch field coil off of the compressor hub .

Fig. 15 Shaft Protector and Puller

Fig. 16 Install Puller Plate

Fig. 17 Clutch Coil Lead Wire

SHAFT PROTECTOR-

Examine the friction surfaces of the clutch pulley

and the front plate for wear. The pulley and front

Troubleshooting