Lamps; Lamp Diagnosis - Jeep Wrangler 1997 Manual

TJ
GENERAL INFORMATION
GENERAL INFORMATION . . . . . . . . . . . .
SAFETY PRECAUTIONS . . . . . . . . . . . . .
DIAGNOSIS AND TESTING
DAYTIME RUNNING LAMP DIAGNOSIS . .
GENERAL INFORMATION
SAFETY PRECAUTIONS
LAMPS
CONTENTS
page
BULB APPLICATION . . . . . . . . . . . . . . . . . . . . . . 15
LAMP DIAGNOSIS . . . . . . . . . . . . . . . . . . . . . . . . 1
HEADLAMP ALIGNMENT . . . . . . . . . . . . . . . . . . . 5 LAMP SERVICE 10
LAMP BULB SERVICE . . . . . . . . . . . . . . . . . . . . . 8 LAMP SYSTEM
. . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . 14
GENERAL INFORMATION
Each vehicle is equipped with various la p assem-
blies. A good ground is necessary for prop r lighting
operation. Grounding is provided by the 1 mp socket
when it comes in contact with the met 1 body, or
through a separate ground wire .
When changing lamp bulbs check the socket for
corrosion. If corrosion is present, clean it ith a wire
brush and coat the inside of the socket li htly with
Mopar Multi-Purpose Grease or equivalen .
WARNING : EYE PROTECTION SHOULD BE USED
WHEN SERVICING GLASS COMPONENTS . PER-
SONAL INJURY CAN RESULT .
CAUTION : Do not touch the glass of hal
with fingers or other possibly oily surfac
bulb life will result .
Do not use bulbs with higher candle
indicated in the Bulb Application table at
this group. Damage to lamp can result.
Do not use fuses, circuit breakers or relays hav-
ing greater amperage value than indica ed on the
fuse panel or in the Owners Manual .
LAMP DIAGNOSIS
page
gen bulbs
reduced
ower than
the end of
INDEX
DIAGNOSTIC PROCEDURES . . . . . . . . . . . . . . . . 1
FOG LAMP DIAGNOSIS . . . . . . . . . . . . . . . . . . . . 3
HEADLAMP DIAGNOSIS . . . . . . . . . . . . . . . . . . . 2
When it is necessary to remove components to ser-
vice another, it should not be necessary to apply
excessive force or bend a component to remove it.
Before damaging a trim component, verify hidden
fasteners or captured edges are not holding the com-
ponent in place.
DIAGNOSIS AND TESTING
LAMPS 8L - 1
page
page
DIAGNOSTIC PROCEDURES
When a vehicle experiences problems with the
headlamp system, verify the condition of the battery
connections, charging system, headlamp bulbs, wire
connectors, relay, high beam dimmer switch and
headlamp switch . Refer to Group 8W Wiring Dia-
grams for component locations and circuit informa-
tion .