Lamp Bulb Service; Headlamp Bulb; Fog Lamp Bulb; Front Park/Turn Signal Lamp Bulb - Jeep Wrangler 1997 Manual

8L - 8 LAMPS
page
REMOVAL AND INSTALLATION
BACK-UP LAMP BULB . . . . . . . . . . . . . . . . . . . . . 9
CENTER HIGH MOUNTED STOP LAMP
(CHMSL) BULB . . . . . . . . . . . . . . . . . . . . . . . . . 9
DOME LAMP . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
FOG LAMP BULB . . . . . . . . . . . . . . . . . . . . . . . . . 8
REMOVAL AND INSTALLATION
HEADLAMP BULB
The headlamp is a sealed unit. Refer to the Head-
lamp Removal/Installation procedure located in the
Lamp Service section of this group .
FOG LAMP BULB
REMOVAL
(1)
Remove the screws that attach the reflector to
the lamp housing .
(2) Separate the reflector from the lamp housing.
(3) Squeeze the bulb retainer together to disengage
it from the reflector.
(4) Remove the bulb/element from the reflector
(Fig. 1).
(5) Disconnect the electrical connector .
Fig. 1 Fog Lamp Bulb
INSTALLATION
(1)
Connect the electrical connector.
(2) Position the bulb/element in the reflector .
LAMP BULB SERVICE
80a20e5f
CAUTION : Do not touch the bulb glass with fingers
or other oily surfaces . Reduced bulb life will result .
INDEX
page
FRONT PARKITURN SIGNAL LAMP BULB . . . . . . 8
HEADLAMP BULB . . . . . . . . . . . . . . . . . . . . . . . . 8
SIDE MARKER LAMP BULB . . . . . . . . . . . . . . . . . 8
TAILJTURN SIGNAL/BACK-UP LAMP BULB . . . . . 8
UNDERHOOD LAMP BULB . . . . . . . . . . . . . . . . . 9
(3) Engage the bulb retainer.
(4) Position the reflector in the lamp housing .
(5) Install the screws that attach the reflector to
the lamp housing .
FRONT PARK/TURN SIGNAL LAMP BULB
REMOVAL
(1)
Remove the park/turn signal lamp bulb socket
via the underside of the fender. Rotate it one-third
turn and separate it from the lamp housing .
(2) Turn the bulb socket and remove it from the
lamp housing.
(3) Pull the bulb straight out of the socket .
INSTALLATION
(1)
Install the bulb in the socket .
(2) Install the bulb and socket in the lamp housing .
SIDE MARKER LAMP BULB
TJ
REMOVAL
(1)
Remove side marker bulb socket via the under-
side of the fender. Rotate it one-third turn and sepa-
rate it from the side marker lamp housing.
(2) Remove the bulb from the socket by pulling it
straight outward .
INSTALLATION
(1)
Install a replacement bulb in the socket .
(2) Install the bulb and socket in the side marker
lamp housing .
TAIL/TURN SIGNAL/BACK-UP LAMP BULB
REMOVAL
(1)
Remove the screws attaching the lens to the
tail lamp housing (Fig. 2).
(2) Separate the lens from the tail lamp housing .
(3) Remove the bulb from the lamp socket.