Back-Up Lamp Bulb; Center High Mounted Stop Lamp (Chmsl) Bulb; Underhood Lamp Bulb; Dome Lamp - Jeep Wrangler 1997 Manual

TJ
REMOVAL AND INSTALLATION (Continued)
Fig. 2 Lens Removal
INSTALLATION
(1) Install a replacement bulb in the lamp socket .
(2) Position the lens on the lamp housing.
(3) Install the screws . Tighten the screws securely.
BACK-UP LAMP BULB
The back-up lamp bulb is located with-in the tail
lamp . Refer to the Tail Lamp Bulb Removal/Installa-
tion procedure.
CENTER HIGH MOUNTED STOP LAMP (CHMSL)
BULB
REMOVAL
(1) Remove the screws attaching the CHMSL lens
to the CHMSL (Fig . 3).
(2) Remove the bulb .
Fig. 3 CHMSL Bulb
INSTALLATION
(1) Install the bulb .
(2) Position the lens on the CHMSL and install the
screws .
UNDERHOOD LAMP BULB
LAMPS 8L - 9
REMOVAL
(1) Disconnect the wire harness connector from the
underhood lamp .
(2) Rotate the bulb counter-clockwise and remove
it from the lamp base socket.
INSTALLATION
(1) Insert a replacement bulb in the lamp base
socket and rotate it clockwise.
(2) Connect the wire harness connector to the lamp.
DOME LAMP
SOUND BAR DOME LAMP BULB REMOVAL
(1) Insert a small flat blade between the lamp and
lamp lens . Carefully pry lamp lens to disengage lens
retaining tabs.
(2) Separate lens from lamp .
(3) Grasp bulb and pull from lamp .
SOUND BAR DOME LAMP BULB INSTALLATION
(1) Position bulb in lamp and press into place.
(2) Position lamp lens on lamp and press into place.
CARGO AREA DOME LAMP BULB REMOVAL
(1) Remove the dome/cargo lamp lens by squeezing it
at the lens at the top and bottom (Fig. 4). This will sep-
arate the lens retaining tabs from the lamp housing
shoulders.
(2) Remove the lens from the lamp housing.
(3) Pull the bulb straight out to remove from the
bulb holder .
SQUEEZE
THE LENS
Fig . 4 Cargo Area Dome Lamp
CARGO AREA DOME LAMP BULB
INSTALLATION
(1) Insert the replacement bulb in the bulb holder.
(2) Position lens at the lamp housing and press
into the housing until the retainer tabs are seated .