Table of Contents
Advertisement
TJ
DISASSEMBLY AND ASSEMBLY (Continued)
(14) Remove converter clutch valve, fail safe valve,
and springs (Fig. 47)
(15) Turn valve body over so transfer plate is fac-
ing upward (Fig. 48). With valve body in this posi-
tion, valve body check balls will remain in place and
not fall out when transfer plate is removed.
(16) Remove screws attaching transfer plate to
valve body (Fig. 48).
(17) Remove transfer plate and separator plate
from valve body (Fig. 48). Note position of filter and
clutch solenoid for reference. Remove valve body
check balls.
(18) Position transfer plate on bench so separator
plate, and filter are facing up. This will avoid having
rear clutch and rear servo check balls fall out when
plates are separated.
Fig. 44 Park Rod
Fig. 45 Converter Clutch Solenoid
TRANSMISSION AND TRANSFER CASE
Fig. 46 Clutch Module And Connecting Tube
Fig. 47 Converter Clutch and Fail Safe Valves
Fig. 48 Valve Body Transfer Plate Screws
21 - 109
Advertisement
Table of Contents
Troubleshooting
