Jeep Wrangler 1997 Manual page 356

Hide thumbs Also See for Wrangler 1997:

Table of Contents

WIPER AND WASHER SYSTEMS

REMOVAL AND INSTALLATION (Continued)

Remove the four screws securing the accessory

switch bezel to the instrument panel (Fig. 17) .

MOUNTING SCREWS

POWER OUTLET/CIGAR LIGHTER

Fig. 17 Accessory Switch Bezel RemoveAnstall

Pull the accessory switch bezel out from the

instrument panel far enough to unplug the wiring

connectors .

(10) Remove the accessory switch bezel from the

instrument panel.

(11) Carefully pry the snap clips at the top and

bottom of the rear wiper/washer switch cavity on the

back of the accessory switch bezel with a small thin-

bladed screwdriver and remove the switch from the

(12) Reverse the removal procedures to install .

Make certain that both of the switch snap clip retain-

ers on the back of the accessory switch bezel are fully

WASHER PUMPS AND RESERVOIR

Disconnect and isolate the battery negative

(2) Remove the three screws securing the washer

reservoir to the inner fender (Fig. 18) .

Fig. 18 Washer Reservoir & Pumps Removel7nstall

(3) Lift the reservoir far enough to unplug the

washer pump wiring connectors .

(4) Disconnect the hoses from the washer pumps,

and drain the solvent from the reservoir into a clean

container for reuse .

(5) Remove the pumps from the reservoir. They are

press-fit into the reservoir grommet seals .

(6) Reverse the removal procedures to install .

Troubleshooting