Shift Boot; Rear Seat - Jeep Wrangler 1997 Manual

Hide thumbs Also See for Wrangler 1997:

Table of Contents

REMOVAL AND INSTALLATION (Continued)

SHIFT BOOT

(1) Using a trim stick, pry the shift boot from the

(2) Using a small flat blade, pry the shift pattern

insert from the shift knob.

(3) Remove the nut attaching the shift knob to the

shift lever (Fig. 64).

(4) Remove the knob and slide the shift boot from

the shift lever.

Fig. 64 Shift Boot

INSTALLATION

(1) Slide the shift boot over the shift lever.

(2) Position the shift knob on the lever and install

(3) Position the shift pattern insert on the knob

and press into place.

(1) Move the front seats to the full forward posi-

(2) Pull on the rear seat latch to disengage the

rear seat from the striker.

(3) Lift the rear seat to the forward tumble posi-

(4) Remove the hitch pins from the seat frame

(5) Slide the seat to the left to disengage the pivot

pin from the pivot bracket.

(6) Slide the seat to the right to disengage the

opposite pivot pin from the pivot bracket (Fig. 65).

(7) Remove the seat through the passenger door

Fig. 65 Rear Seat