Table of Contents
Advertisement
TJ
REMOVAL AND INSTALLATION (Continued)
(11) Position the front end lighting wire harness
into the retainers on the fender. Engage the retainers
to secure.
(12) Position the high pressure air conditioning
line into the retainer on the fender. Engage the
retainer to secure.
(13) Position the PDC on the fender and install the
bolts.
(14) Position the PDC wire harness into the
retainers on the fender and battery tray. Engage the
retainers to secure.
(15) Install the air cleaner housing.
(16) Install and connect the battery.
LEFT FENDER REMOVAL
(1) Disconnect the negative terminal on the bat-
tery.
(2) Remove the windshield washer reservoir.
(3) Disengage horn wire connectors.
(4) Remove horns.
(5) Remove EVAP canister.
(6) Remove the bolts attaching the ABS Hydraulic
Control Unit (HCU) to the support tray.
(7) Secure the HCU.
(8) Remove the HCU tray.
(9) Disengage the front end lighting wire harness
retainers on the fender.
(10) Disengage the headlamp wire connector.
(11) Route the fog lamp (if equipped), park lamp
and side marker wire harness through the access
hole in the fender well.
(12) If equipped, remove the body side molding
(Fig. 14).
(13) Remove the bolts attaching the fender to the
cowl (Fig. 15).
(14) Remove the bolts attaching the fender to the
HCU tray reinforcement bracket.
(15) Remove the bolts attaching the fender to the
grille.
(16) Separate the fender from the vehicle.
LEFT FENDER INSTALLATION
Transfer all related components. Replace harness
retainers if damaged.
(1) Position the fender on the vehicle.
(2) Install the bolts attaching the fender to the
grille.
(3) Position the front end lighting wire harness
into the retainers on the fender. Engage the retainers
to secure.
(4) Install the bolts attaching the fender to the
HCU tray reinforcement bracket.
(5) Install the bolts attaching the fender to the
cowl.
(6) If equipped, install the body side molding.
(7) Route the fog lamp (if equipped), park lamp
and side marker wire harness through the access
hole in the fender well. Seat the grommet
(8) Engage the headlamp wire connector.
(9) Install the HCU tray.
(10) Position the HCU on the support tray and
install the bolts.
(11) Install EVAP canister.
(12) Install horns.
(13) Engage horn wire connectors.
(14) Install the windshield washer reservoir.
(15) Connect the negative terminal on the battery.
BODY SIDE MOLDING
REMOVAL
(1) Remove the bolts from underside of the body
side molding (Fig. 16).
(2) Lift the molding upward to release it from the
molding support.
(3) Remove the molding support by drilling out the
rivets.
Fig. 16 Body Side Molding
INSTALLATION
(1) If removed, position the molding support on the
body and install the rivets.
(2) Place the upper edge of the molding over the
top of the molding support and slide it downward.
(3) Install the bolts into the underside of the body
side molding.
SIDE STEP
REMOVAL
(1) Remove the bolts that attach the side step to
the frame (Fig. 17).
(2) Separate the side step from the frame.
INSTALLATION
(1) Position the side step on the frame.
BODY
23 - 21
Advertisement
Table of Contents
Troubleshooting
