Table of Contents
Advertisement
9 - 28
2 .5L ENGINE
REMOVAL AND INSTALLATION (Continued)
Fig. 21 Rear Mount (Manual Transmission)
(2) Remove the bolts holding the transmission sup-
port bracket to transmission .
(3) Remove the transmission support bracket .
Fig. 22 Rear Mount (AutomaticTransmission)
80a35455
INSTALLATION
TJ
MANUAL TRANSMISSION :
(1) Position the transmission mount bracket to the
transmission and install the bolts (Fig . 21) .
(2) Tighten the bolts to 54 N-m (40 ft. lbs .) torque .
(3) Position the support cushion to the transmis-
sion mount bracket and install nuts (Fig . 21) .
(4) Tighten the nuts to 41 N-m (30 ft . lbs .) torque .
AUTOMATIC TRANSMISSION :
(1) Position the transmission mount bracket to the
transmission and install the bolts . Tighten the bolts
to 54 N-m (40 ft . lbs .) torque .
(2) Position the support cushion to the transmis-
sion mount bracket and install nuts . Tighten the
nuts to 41 N-m (30 ft. lbs .) torque (Fig. 22) .
(3) If the support cushion bracket was removed
from the skid plate, position the bracket on the skid
plate and install the nuts and bolts. Tighten the nuts
to 28 N-m (21 ft . lbs .) torque .
ALL TRANSMISSIONS
(1) Position the skid plate to the studs of the sup-
port cushion and install the nuts (Fig. 21) (Fig. 22) .
Tighten the nuts to 28 N-m (21 ft. lbs .) torque .
(2) Install the skid plate bolts to the sill and
tighten to 75 N-m (55 ft . lbs .) torque .
(3) Remove the transmission support .
(4) Lower the vehicle .
(5) Connect negative cable to battery.
ENGINE ASSEMBLY
REMOVAL
(1) Place a protective cloth over the windshield
frame . Raise the hood and rest it on the windshield
frame .
(2) Disconnect
the
battery
cable
clamps
and
remove the battery.
WARNING :
THE COOLANT IN A RECENTLY OPER-
ATED ENGINE IS HOT AND PRESSURIZED . USE
CARE TO PREVENT SCALDING BY HOT COOLANT.
CAREFULLY RELEASE THE PRESSURE BEFORE
REMOVING THE RADIATOR DRAIN COCK AND CAP.
(3) Remove the radiator drain cock and radiator
cap to drain the coolant . DO NOT waste usable cool-
ant . If the solution is clean, drain the coolant into a
clean container for reuse .
(4) Disconnect the wire connectors from the gener-
ator.
(5) Disconnect the ignition coil and distributor
wire connectors.
(6) Disconnect the oil pressure sender wire connec-
tor.
Advertisement
Table of Contents
Troubleshooting
