Table of Contents
Advertisement
TJ
DISASSEMBLY AND ASSEMBLY (Continued)
DISASSEMBLY
(1) Remove input shaft and output shaft pilot
bearing from output shaft (Fig. 111), if necessary.
(2) Measure and note thrust clearance of output
shaft gears (Fig. 112). First gear clearance should be
0.10 – 0.40 mm (0.004 – 0.0197 in.). Second and third
gear clearance should be 0.10 – 0.30 mm (0.003 –
0.0118 in.).
Fig. 111 Remove Output Shaft Pilot Bearing
TRANSMISSION AND TRANSFER CASE
Fig. 110 Output Shaft And Gears
Fig. 112 Check Output Shaft Gear Thrust Clearance
21 - 67
Advertisement
Table of Contents
Troubleshooting
