Table of Contents
Advertisement
21 - 114
TRANSMISSION AND TRANSFER CASE
DISASSEMBLY AND ASSEMBLY (Continued)
(39) If necessary, insert park rod end into manual
lever and install E-clip (Fig. 63).
Fig. 63 Park Rod
(40) Insert detent spring and ball into opening in
valve body and install Retainer Tool 6583 (Fig. 64).
(41) Install manual valve into valve body (Fig. 65).
(42) Insert throttle lever through transfer plate
side of valve body and upward (Fig. 66).
(43) Insert throttle lever into groove in manual
valve (Fig. 67).
(44) Install seal, washer, and E-clip to retain man-
ual shaft to valve body (Fig. 66).
(45) Install switch valve and spring, pressure reg-
ulator valve and spring, kickdown valve and spring,
and throttle valve into valve body (Fig. 68).
(46) Place adjusting screw bracket and line pres-
sure adjusting screw in position on valve body and
compress springs (Fig. 40).
(47) Install screws to attach adjuster bracket to
valve body.
Fig. 64 Securing Detent Ball And Spring With
Retainer Tool
Fig. 65 Manual Valve
Fig. 66 Manual And Throttle Levers
Fig. 67 Manual Valve And Throttle Lever Alignment
TJ
Advertisement
Table of Contents
Troubleshooting
