Right Fender Installation; Body Side Molding - Jeep Wrangler 1997 Manual

Hide thumbs Also See for Wrangler 1997:

Table of Contents

REMOVAL AND INSTALLATION (Continued)

(7) Disengage the front end lighting wire harness

retainers on the fender.

(8) Remove the battery tray.

(9) Disengage the battery temperature sensor con-

(10) Disengage the vacuum line at the reservoir

under the battery tray reinforcement bracket.

(11) Disengage the headlamp wire connector.

(12) Route the fog lamp (if equipped), park lamp

and side marker wire harness through the access

hole in the fender well.

(13) If equipped, remove the fender flare extension

and body side molding (Fig. 14).

(14) Remove the bolts attaching the fender to the

cowl (Fig. 15).

(15) Remove the bolts attaching the fender to the

battery tray reinforcement bracket.

(16) Remove the bolts attaching the fender to the

(17) Separate the fender from the vehicle.

RIGHT FENDER INSTALLATION

Transfer all related components. Replace harness

retainers if damaged.

(1) Position the fender on the vehicle.

(2) Install the bolts attaching the fender to the

(3) Install the bolts attaching the fender to the

battery tray reinforcement bracket.

(4) Install the bolts attaching the fender to the

(5) If equipped, install the fender flare extension

and body side molding.

(6) Route the fog lamp (if equipped), park lamp

and side marker wire harness through the access

hole in the fender well. Seat the grommet

(7) Engage the headlamp wire connector.

(8) Engage the battery temperature sensor connec-

(9) Engage the vacuum line at the reservoir under

the battery tray reinforcement bracket.

(10) Install the battery tray.

Fig. 15 Front Fender

Fig. 14 Body Side Molding