Table of Contents
Advertisement
TJ
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 55 Installing Rear Bearing In Retainer
(3) Install input gear in low range gear. Be sure
input gear is fully seated.
(4) Install remaining thrust washer in low range
gear and on top of input gear. Be sure washer tabs
are properly aligned in gear notches.
(5) Install retainer on input gear and install snap-
ring.
Fig. 56 Input/Low Range Gear Components
TRANSMISSION AND TRANSFER CASE
INPUT GEAR AND LOW RANGE GEAR INSTALLATION
(1) Align and install low range/input gear assem-
bly in front case (Fig. 57). Be sure low range gear
pinions are engaged in annulus gear and that input
gear shaft is fully seated in front bearing.
(2) Install snap-ring to hold input/low range gear
into front bearing (Fig. 58).
Fig. 57 Input/Low Range Gear Installation
Fig. 58 Install Snap-Ring
(3) Clean gasket sealer residue from retainer and
inspect retainer for cracks or other damage.
(4) Apply a 3 mm (1/8 in.) bead of Mopar gasket
maker or silicone adhesive to sealing surface of
retainer.
(5) Align cavity in seal retainer with fluid return
hole in front of case.
21 - 183
Advertisement
Table of Contents
Troubleshooting
