Blower Motor Switch; Temperature Control Cable - Jeep Wrangler 1997 Manual

24-28
HEATING AND AIR CONDITIONING
REMOVAL AND INSTALLATION (Continued)
Fig. 28
Heater-AIC Control Remove/Install
HEATER-A/C CONTROL
Fig. 29
Heater-AIC Control Connectors
BLOWER MOTOR
SWITCH
CONTROL CABLE
CONNECTOR
80a1d30s
(7)
Disconnect the temperature control cable and
cable housing from the heater-A/C control .
(8) Remove the heater-A/C control from the instru-
ment panel .
INSTALLATION
(1)
Connect the temperature control cable and
cable housing to the heater-A/C control .
(2) Plug the three electrical connectors into the
heater-A/C control .
(3) Install the heater-A/C control to the instrument
panel with four screws .
(4) Reach through the glove box opening and plug
the two halves of the vacuum harness together.
(5) Install the glove box and the instrument panel
center bezel. Refer to Group 8E - Instrument Panel
Systems for the procedures .
(6) Connect the battery negative cable .
BLOWER MOTOR SWITCH
WARNING : ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO GROUP 8M - PASSIVE
RESTRAINT SYSTEMS BEFORE ATTEMPTING
STEERING WHEEL, STEERING COLUMN, OR
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE . FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY
(1)
Disconnect and isolate the battery negative
cable.
(2) Pull the blower motor switch knob on the front
of the heater-A/C control off of the blower motor
switch stem.
(3) Remove the heater-A/C control as described in
this group.
(4) Remove the two screws securing the blower
motor switch to the rear of the heater-A/C control
and remove the switch (Fig. 30) .
BLOWER MOTOR
SWITCH
Fig. 30 Blower Motor
Switch Removellnstall
(5)
Reverse the removal procedures to install .
TEMPERATURE CONTROL CABLE
TJ
80a4d307
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS,
REFER
TO
GROUP 8M - PASSIVE
RESTRAINT SYSTEMS BEFORE
ATTEMPTING
STEERING WHEEL, STEERING COLUMN, OR
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1)
Disconnect and isolate the battery negative
cable.
(2) Remove the heater-A/C control as described in
this group.
(3) Disconnect the cable retainer from the heater-
A/C housing (Fig. 31) .
(4) Remove the push nut attaching the cable to the
blend air door crank arm and remove the cable.
(5) Reach through the glove box opening to route
the cable through the strap retaining it to the heater-
A/C housing support bracket o the dash panel, and