Installation Setup > Outside Temp > Parameters, Counters, Signals; Installation Setup > Digital Input > Parameters, Counters, Signals; Installation Setup > Analogue Input > Parameters, Counters, Signals - DeDietrich MIT-M /E Installation, User And Service Manual

7 Settings
Tab.88 Parameters
Parameter Description
Outdoor sensor Enable outdoor sensor
(AP056 )
No outside sensor
AF60
QAC34
Summer Winter Outdoor temperature: upper limit for heating
(AP073) Can be set from 15 °C to 30.5 °C
Season cross-over Temperature variance from set outdoor upper temp. limit in which the generator
(AP075) will not heat or cool
Can be set from 0 to 10 °C
Tab.89 Parameters
Parameter Description
Digital input config Sets the general configuration of the digital input
(EP046)
Stop heating + DHW
Stop heating
Stop DHW
Forced setpoint
Buffer Tank input
Logic level Digi In Sets the logic level contact of the Smart Control Board digital input
(EP056)
Open
Closed
Off
Req FlowSetp digi In Requested flow setpoint when digital input is configured to forced heat
(EP066) Can be set from 7 °C to 100 °C
72 MIT-M
7.4.8 Installation Setup > Outside temp > Parameters,
counters, signals
7.4.9 Installation Setup > Digital input > Parameters, counters,
signals
EP : Entry Parameters = Input parameters
7.4.10 Installation Setup > Analogue input > Parameters,
counters, signals
EP : Entry Parameters = Input parameters
Factory setting
SCB-10
1
22
4
Factory setting
SCB-10
Stop heating + DHW
Closed
80
7756241 - v02 - 19062020