Tail Section And Rear Frame Assembly - Buell P3 Service Manual

HOME

TAIL SECTION AND REAR FRAME ASSEMBLY

REMOVAL - TAIL SECTION
1. Remove seat. See 2.28
2. See Figure 2-110. Remove fasteners and clamp (3, 19
and 20).
3. Remove tree fasteners (2).
4. Remove fairing, tail section (1).
11 1
WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a)
1. Fairing, tail section
2. Tree fastener
3. Bolt
4. Bolt
5. License plate bracket
6. Turn signal
7. Lock washer
8. Nut
9. Nut
10. Rear frame
11. Bolt
12. Rear subframe mounting bracket
13. Screw
14. Bushing
15. Seat latch lever
16. Washer
17. Seat latch spring
18. Bolt
19. Bolt
20. Clamp
6
2-66 2007 Buell P3: Chassis
SEAT.
WARNING
5
7
20
Figure 2-110. Tail Section
5. Disconnect battery negative cable.
6. Unplug taillight.
7. Cut cable strap holding taillight and turn signal wires.
8. Unplug turn signals.
9. Remove nut (8) and lock washer (7).
10. Remove turn signals (6).
11. Remove nuts and flat washers from back of taillight.
12. Remove taillight.
13. Remove bolts (4) and nuts (9).
14. Remove license plate bracket (5).
4
3
9
8
10
12
14
19
13
16
15
17
18
2.25
1
11
a0146a2x
2