HOME
HEADLIGHT ASSEMBLY AND SUPPORT BRACKET
REMOVAL
1.
Remove seat. See
2.38
11
1
WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a)
2.
Disconnect battery by unthreading fastener removing
negative cable (black) from battery first. See
TERY MAINTENANCE.
3.
Remove front fairing. See
SHIELD, AND
MIRRORS.
4.
See
Figure 2-102.
Disconnect flasher (1) and bank angle
sensor (2). Remove electronic control module fasteners
(3).
5.
See
Figure 2-104.
Rotate headlamp support bracket.
a.
Loosen headlamp pivot fasteners (1).
b.
Rotate headlight bracket (2) down.
6.
See
Figure 2-103.
Disconnect headlight connection.
7.
Disconnect and remove electronic control module. See
4.30 ELECTRONIC CONTROL
8.
See
Figure
2-104.
bracket (2).
SEAT.
WARNING
1.5 BAT-
2.37 FRONT FAIRING, WIND-
MODULE.
Remove
headlight
support
8428
6775
1
1.
Flasher
2.
Bank angle sensor
3.
Electronic control module
Figure 2-102. Headlight Support Bracket
8470
Figure 2-103. Headlight Connector
2005 Buell Firebolt: Chassis
2.25
3
2
2-71