Installing The Lower Triple Clamp - KTM Freeride E-SX Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.10

Installing the lower triple clamp

0 0
–
Remove screw
–
Remove screw
–
Take off the upper triple clamp with the handlebar and set it aside.
C00836-10
–
Remove O-ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
C00693-10
Main work
(Freeride E‑SX)
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering
head bearing.
–
Check whether the upper steering head seal
–
Push the protective ring
C00759-10
–
Position the upper triple clamp with the handlebar.
–
Mount screw
–
Position the rear wheel brake line and wiring harness.
C00695-10
–
Position the fork legs.
Bleeder screws
C00696-10

.

.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.

and protective ring
p. 119)
 and O-ring

but do not tighten yet.
 face forward.
Info
The lowest milled groove in the fork leg must be flush with the top edge
of the upper triple clamp.
The support for the brake caliper is attached to the left fork leg.

.

is correctly positioned.
 onto the steering stem.
55