14
WHEELS, TIRES
14.4
Installing the rear wheel
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Main work
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Clean and grease the shaft seal rings
Long-life grease (
–
Insert the spacers.
C00736-11
–
Position the rear wheel.
The brake linings are correctly positioned.
–
Insert wheel spindle
–
Put the chain on.
C00737-10
–
Position chain adjuster
–
Make sure that chain adjusters
–
Check the chain tension. (
–
Tighten nut
Guideline
Nut, rear wheel spindle
Info
The wide adjustment range of the chain adjusters enables different sec-
ondary ratios with the same chain length.
Chain adjusters
–
Operate the rear brake lever several times until the brake linings are in contact with
the brake disc and there is a pressure point.
C00707-11
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Install the KTM PowerPack. (
–
Lock the seat. (
p. 119)
.
. Mount nut
are fitted correctly on adjusting screws
p. 66)
.
can be turned by 180°.
p. 94)
p. 63)
and contact surface
of the spacers.
, but do not tighten it yet.
M20x1.5
80 Nm (59 lbf ft)
p. 49)
83
.