12
SERVICE WORK ON THE CHASSIS
12.18
Removing the shock absorber
12.19
Installing the shock absorber
Preparatory work
–
Deactivate the vehicle. (
–
Fold the seat up. (
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
–
Raise the motorcycle with the lift stand. (
Main work
–
Remove screw
–
Remove screw
without blocking the rear wheel. Fix the rear wheel in this position.
–
Remove screw
–
Push the splash protector
C00701-10
Main work
–
Push splash protector
–
Mount and tighten screw
Guideline
Screw, top shock absorber
–
Mount and tighten screw
Guideline
C00701-11
Screw, bottom shock
absorber
Info
The heim joint for the shock absorber at the swingarm is Teflon-coated. It
must not be greased with grease, nor with any other lubricants. Lubricants
dissolve the Teflon coating, thereby drastically reducing the service life.
–
Mount and tighten screw
Guideline
Screw, upper subframe
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Install the KTM PowerPack. (
–
Lock the seat. (
p. 37)
p. 63)
p. 94)
p. 64)
.
and lower the rear wheel with the swing arm as far as possible
.
to the side and remove the shock absorber.
to the side and position the shock absorber.
.
M12
.
M12
.
M10
p. 94)
p. 63)
p. 49)
80 Nm
Loctite
®
(59 lbf ft)
80 Nm
Loctite
®
(59 lbf ft)
45 Nm
Loctite
®
(33.2 lbf ft)
p. 49)
62
2701™
2701™
243™