19
SERVICE WORK ON THE MOTOR
19.1
Changing the gear oil
Warning
Danger of scalding Gear oil becomes very hot when the motorcycle is operating.
–
Wear suitable protective clothing and safety gloves.
–
If you have been scalded, hold the burn under lukewarm water immediately.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, cleaning agents, brake fluid etc. properly and in compliance with the applicable regulations.
Info
Drain the gear oil while the motor is warm.
Preparatory work
–
Stand the motorcycle on its side stand on a horizontal surface.
–
Deactivate the vehicle. (
–
Fold the seat up. (
–
Remove the KTM PowerPack. (
–
Mount the covering cap. (
Main work
–
Place a suitable container under the motor.
–
Remove oil drain plug
C00745-10
–
Remove screw plug
–
Let the gear oil drain fully.
C00748-10
–
Mount and tighten the oil drain plug
Guideline
Oil drain plug with magnet
–
Place the motorcycle on its left side with the aid of an assistant.
C00746-10
–
Fill the special tool
Oil filler syringe (58429048000)
Gear oil
–
Fill the gear oil using the special tool.
–
Wipe away any excess gear oil.
Info
The screw plug is not used for checking the oil level!
C00747-10
p. 37)
p. 63)
p. 94)
p. 64)
.
.
.
M12x1.5x12
with the specified quantity of gear oil.
0.2 l (0.2 qt.)
Gear oil (SAE 80W/90) (
105
20 Nm
(14.8 lbf ft)
p. 118)