KTM Freeride E-SX Owner's Manual page 59

12 SERVICE WORK ON THE CHASSIS
0 0
(Freeride E‑XC)
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering
head bearing.
–
Check whether the upper steering head seal
–
Push the protective ring
C00759-10
–
Position the upper triple clamp with the handlebar.
–
Mount screw
–
Position the rear wheel brake line and wiring harness.
C00834-10
–
Position the fork legs.
Bleeder screws
C00832-10
–
Tighten screws
Guideline
Screw, bottom triple clamp
C00833-10
–
Tighten screw
Guideline
Screw, top steering head
C00831-10
p. 119)
 and O-ring

but do not tighten yet.

face forward.
Info
The lowest milled groove in the fork leg must be flush with the top edge
of the upper triple clamp.
The support for the brake caliper is attached to the left fork leg.

.

.

is correctly positioned.
 onto the steering stem.
M8 18 Nm
(13.3 lbf ft)
M20x1.5 12 Nm
(8.9 lbf ft)
57