13
BRAKE SYSTEM
Main work
–
Move the brake fluid reservoir attached to the left of the handlebar to a horizontal
position.
–
Remove screws
–
Remove cover
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir, extracting brake fluid if necessary.
C00728-11
–
Remove cotter pins
–
Remove pins
–
Take off retaining spring
–
Clean the brake caliper.
C00732-10
–
Position the new brake linings.
Info
Always change the full set of brake linings.
C00733-01
–
Position retaining spring
–
Mount bolt
Info
To make it easier to mount the pin, push the retainer spring down.
Make sure the retaining spring is seated correctly.
–
Mount cotter pin
–
Operate the rear brake lever several times until the brake linings are in contact with
C00732-10
the brake disc and there is a pressure point.
–
Fill up the brake fluid to the level
Guideline
Level
tainer rim)
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
C00728-12
Clean up overflowed or spilt brake fluid immediately with water.
Finishing work
–
Install the KTM PowerPack. (
–
Lock the seat. (
.
with membrane
.
.
.
and remove the brake linings.
.
.
.
.
(brake fluid level below con-
p. 118)
p. 94)
p. 63)
5 mm (0.2 in)
80