Removing The Covering Cap; Checking The Battery Discharge Plug Form Ring; Checking For Chain Dirt Accumulation; Cleaning The Chain - KTM Freeride E-SX Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.25

Removing the covering cap

Note
Material damage Components damaged or destroyed by water or dirt.
–
Mount the covering cap if you have removed the KTM PowerPack.
12.26

Checking the battery discharge plug form ring

12.27

Checking for chain dirt accumulation

12.28

Cleaning the chain

Warning
Danger of accidents Oil or grease on the tires reduces their grip.
–
Remove oil and grease with a suitable cleaning material.
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, cleaning agents, brake fluid etc. properly and in compliance with the applicable regulations.
Main work
–
Remove the covering cap
C00721-10
Finishing work
–
Install the KTM PowerPack. (
–
Lock the seat. (
Condition
The KTM PowerPack has been removed.
The covering cap has been removed.
–
Check the battery discharge plug form ring
» If the battery discharge plug form ring is dirty:
–
Ascertain that the discharge plug is de-energized.
–
Clean the form ring without using water or compressed air.
–
Cover the contacts and spray silicone spray onto the form ring.
» If the battery discharge plug form ring is damaged:
–
Change the battery discharge plug form ring.
C00776-10
–
Check the chain for coarse dirt accumulation.
» If the chain is very dirty:
–
Clean the chain. (
400678-01
 with one hand.
p. 94)
p. 63)

p. 65)
on the electric motor.
65